Limestone products are metallurgy, sugar, chemicals, cement and other industries one of the main accessorial material, according to the general standards can be divided into two major categories of lump ore and fines ore, In addition to cement manufacturing industry, other industries demand are based on lump ore products. Limestone production limited by the crushing crafts, geology and other conditions, the production rate of powder ore up to 40% to 60%, While small demand for the fines ore market, due to unbalanced production and sales, The backlog of a large number of fines ore is one of the main problems of limestone production, Lots of limestone production enterprises are seeking to reduce the rate of powder mineral and method of increasing the block mineral yield.
Through the analysis, it is found that the main reason for the high rate of powder mineralization in the crushing and screening system is that the crushing process and equipment selection is unreasonable, the screening efficiency of the vibrating screen is low and the massive lump ore flows into the powder ore; In the crushing and screening process, the internal transport impact, resulting in secondary crushing, but also to increase the powder ore. Therefore, from the above two aspects of analysis, to take measures.
In the crusher selection, we believe that because of the need to reduce the fines ore and reduce maintenance costs, should be used cone crusher, to minimize the use of hammer crusher. Although the cone crusher initial investment cost, but considering the human cost, mechanical fuel consumption, maintenance costs, safety performance and supply demand, cone crusher is still the best choice for limestone crushing equipment, hammer crusher high loss rate, Maintenance costs are gradually replaced by cone crusher.
*All of our products are made with care and covered for 1 year warranty!
*Installation and Operator Training FREE
KINGLINK manufactures and installs stationary type stone crushing and screening plants according to customer requirements. Production capacity of our stationary plants differs from100 to 1000 ton per hour.
200-350 Tons/hour capacity of Crushing and Screening Plant:
-35 m3 Rock Feeding Bunker
-Vibrating Grizzly Feeder (bypass)
-Primary Jaw Crusher
-Vibrating Bypass Screen
-Secondary Cone Crusher/Impact Crusher
-2400 x 6000 mm Vibrating Screen (4 decks)
-Mid transit Hopper
-KL VSI Vertical Shaft Impact Crusher
-1000 mm, 800 mm, 650 mm width Conveyor Belt System
-Control Panel and Automation System
-Magnetic Magnet
FOR FURTHER INFORMATION PLEASE FEEL FREE TO CALL US!!!
Audited Supplier 
){kind=link}
){kind=link}